SWANY

(1)The cutting process of leather gloves

1.The cutting process of leather gloves

(1)The cutting process

Here the cutting process of leather is shown.

The basic process

1.Making drawings according to the instructions

2.Making the matrix

3.The cutting

Cutting of a metal mold, keeping in mind the direction of stretching of the leather

Special care must be taken when stretching the area for the fingers.

	→		These molds are used for the approximate cutting.
▲Wire molds for rough cutting		▲After the rough cutting	These molds are used for the approximate cutting.
	→		These molds are used for the final cutting.
▲Wire molds for the final cutting		▲After the final cutting

Next, the decoration is applied.

1.To make the decoration, small holes are punched over a matrix.

2.Pulling a thread through the furigara “3 snakes” pattern

3.The decoration completed

(1)The cutting process of leather gloves